Error Messages - Weidmüller THM Basic 300 Mode D'emploi

6. Troubleshooting
6.1

Error messages

Errors and malfunctions are displayed by one or several flashing LEDs.
The READY and
MEDIA LED are
flashing at the same
time.
The READY and
RIBBON LED are
flashing at the same
time.
The READY LED is
flashing.
Table 4 Error messages
1168670000/02/08.11
All manuals and user guides at all-guides.com
Possible cause
The label gaps or sheen
markings are not recog-
nized.
The label roll is finished.
There is a label blockage.
The labels are not being
detected correctly.
The ribbon roll is finished.
There is a ribbon blockage.
The film is not being de-
tected properly.
There is a serial interface
error.
A memory overflow has oc-
curred.
Remedy
Check the label guide.
Check the position of the
label sensor.
Calibrate the label sensor.
Insert new labels.
Clear the blockage.
Replace the label sensor.
Insert a new ribbon.
Clear the blockage.
Replace the ribbon sen-
sor.
Check the baud rate and
DIP switch settings.
Restart the printer.
Reset the printer.
Troubleshooting
Comment
Check your software
settings if you are us-
ing continuous-feed
print materials.
This should only be
carried out by a ser-
vice technician.
49