Genesis GCD18CP Manuel D'utilisation page 4

All manuals and user guides at all-guides.com
Keep tool handles dry, clean and free from oil and grease.
•
safely control the tool.
TOOL USE AND CARE
Secure the work piece
•
Holding the work piece by hand or against your body is unstable and may lead to loss of control.
Do not force the power tool.
•
which it is designed. forcing the tool could possibly damage the tool and may result in personal injury.
Use the correct power tool for the job
•
which it is not designed.
Do not use tool if switch does not turn it on or off.
•
with the switch is dangerous and must be repaired or replaced by an authorized service center.
Turn power tool off, and disconnect the plug
•
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
Store idle tool out of reach of children and other inexperienced persons
•
dangerous in the hand of untrained users.
Maintain power tools with care
•
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part
that is damaged must be properly repaired or replaced by an authorized service center to avoid risk of
personal injury.
Use recommended accessories
•
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
•
edges are less likely to bind and are easier to control.
Feed the work piece in the correct direction and speed.
•
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the work piece in the same direction may cause the work piece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
•
until it comes to a complete stop.
Never start the power tool when any rotating component is in contact with
•
the work piece.
WARNING:
USE OF THIS TOOL CAN GENERATE AND DISBURSE DUST OR
OTHER AIRBORNE PARTICLES, INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST
AND ASBESTOS. Direct particles away from face and body. Always operate tool in a
well-ventilated area and provide for proper dust removal. Use dust collection system
wherever possible. Exposure to the dust may cause serious and permanent respiratory
or other injury, including silicosis (a serious lung disease), cancer, and death. Avoid
breathing the dust, and avoid prolonged contact with the dust. Allowing dust to get into
your mouth or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate for
dust exposure, and wash exposed areas with soap and water.
SERVICE
• Have your power tool Serviced by a qualified repair person using
replacement parts. This will ensure that the safety of the power tool is maintained.
Service your power tool periodically
•
portion of the tool since internal wires may be misplaced or pinched.
SAVE THESE INSTRUCTIONS
18V Cordless Drill/Driver
Operator's Manual
. use clamp or other practical way to hold the work piece to a stable platform.
The tool will perform the job better and safer at the feed rate for
. Don't force the tool or attachment to do a job for
. Check for proper alignment and binding of moving parts,
. using accessories and attachments not recommended by the
. Properly maintained cutting tools with sharp cutting
. When cleaning a tool, be careful not to disassemble any
Slippery handles cannot
Any tool that cannot be controlled
from the power source and/or battery pack
feed the work piece into a
. Do not leave the tool
only identical
GCD18CP
. It is