JETI model MEZON 40 Pro LMR Notice D'utilisation page 22

All manuals and user guides at all-guides.com
Modes: Soft, Medium, and Hard are the predefined brake modes.
Each brake mode is defined by the following parameters: „Initial
Performance"-> „End Power" -> „Delay" and „Speed
parameters". After selecting the mode, all parameters of the
mode are displayed. In the Manual mode individual parameters
can be edited and modified. The Proportional brake mode sets
the braking effect according to the throttle position.
4.3 Cut-off voltage
•
You set the cut-off voltage
of the controller in the
" D ev i ce E x p l o r e r " - >
" M e z o n P r o "
>"Limitations" menu.
The default cut-off voltage is set
to 3.2V per cell with automatic
detection of the number of Li-XX
cells. The Automatic mode works
properly only if you connect fully
c h a r g e d b a t t e r i e s t o t h e
controller.
4.4 Motor configuration
It is necessary to configure the
number of motor poles and the
gear ratio (if the motor has gears)
f o r c o r r e c t r e v o l u t i o n
measurement.
•
Set the number of motor
poles /gear ratio in the menu
"Device Explorer" -> "Mezon
Pro" -> "Motor Configuration".
-
22
EN