Commissioning - BASETech 26 00 47 Notice D'emploi

9. Commissioning

Place the rechargeable battery in the "battery compartment" (10).
Connect the mains adapters included in the delivery to the power supply connections "DC6V 800mA"
(12/17). Connect the plug-in mains adapters to standard household mains sockets (230V/AC 50 Hz).
Set the "channel selection switch" (7) at the receiver to position 1. The receiver channel determined this
way corresponds to the transmitter channel of the camera included in the supply.
Then switch on the receiver with screen. For this, put the "POWER" (11) slider in the desired position:
Position A/V
Position A
Set the desired "display" (4) brightness with the "Brightness" (2) buttons. Set the volume with the "Volume"
(5) buttons. If required, rotate the display view with the "Rotation" button.
Now take the camera. On the back of the camera, there are "holes for hanging up" (18) for wall moun-
ting. Of course the camera can also be operated easily e.g. on a table.
We recommend keeping a safety distance of at least 1m to your child. Also observe the
safety notes in chapter 4.
Now switch on the camera. For this, put the "POWER" (19) slider in the ON position. The "POWER" status
LED lights up green.
Adjust the camera to the desired position.
The infrared "LEDs" (16) enable seeing in darkness at a range of approx. 1.5 to 2 metres.
Please note that the images turn from colour to black/white with increasing darkness and
the resulting activation of the IR-LEDs. Brightness is recognised by the camera through a
photo sensor at the front.
Observe that the camera is programmed for the screen ex works. If no connection is
made anyway, there is a pairing button on the back of the camera. Press the pairing but-
ton (e.g. with a paper clip) to start a connection search. If necessary, turn the camera off
and on again.
All manuals and user guides at all-guides.com
= Audio and video signal reception
= Audio signal reception without video signal
23