Main Components - AERMEC FCLI 32 Manuel D'installation

MAIN COMPONENTS

1 Grille with air filter (
GLLI-GLFI
2 Air delivery deflector (
GLLI-GLFI
3 Grille frame ( )
GLLI-GLFI
4 Tray
5 Inverter device
FCLI (module 600)
(GLLI100) (GLLI100N) (GLLI100EH)
12 11
10
13
FCLI (Module 840)
GLLI 20
13
DESCRIPTION
The FCLI cassette-type fan coil is a room air
treating unit. The FCLI concentrates high
technological and functional characteris-
tics that make it the ideal climate control
unit for all types of room. The supply
of climate-controlled air is distributed
throughout the room. FCLI generates
heat if included in a heating system with
boiler or heat pump, but may also be
used in the summer as an air conditioner
if the heating system has a water chiller.
The fan coils are designed for 2- and 4-pipe
systems.
The unit is installed in a suspended ceiling
with the possibility to send conditioned
air to adjacent rooms and introduce
external air regardless of unit ventila-
tion. Thanks to its dimensions, the FCLI
22
) 6 Base unit
) 7 Fastening brackets
8 Electrical box
9 Water connections (only for 4 pipes)
10 Water connections (2 pipes)
9
8
7
2
1
10
12
with "module 600" can be perfectly inte-
grated in standard 600x600 suspended
ceiling panelling.
BASE
The unit has an integrated metal struc-
ture. The load-bearing base is in galva-
nised sheet steel and is varnished with
polyester powders. The following are
fixed to the base: fixing brackets, coils,
motor and fan, condensate discharge
pump, attachment plate, control board
unit and condensate drip tray. By means
of the flanges, it allows the channels (for
renewing environmental air and/or deliv-
ery to an adjacent room) to be joined to
the sides.
FASTENING BRACKETS
FCLI (module 600)
(GLFI10) (GLFI10N) (GLFI10M) (GLFI10EH)
12
6
13
4
3
8
9
11
1
11 Air drain valve
12 Push-out, coupling for air delivery in an
adjacent room
13 Condensate drain
11 10 9 8
1
2
7
2
Galvanised steel clamps for attaching the
unit to the ceiling.
TRAY
Tray closing off the unit. Made of injec-
tion co-moulded polystyrene to avoid
thermal dispersion and the formation of
condensate, it conveys conditioned air
towards the fins and from the conden-
sate drip tray.
The air suction conveyor is equipped with
a protective grille that impedes access to
the moving fan.
THERMAL EXCHANGE COIL
The coils used have copper pipes and cor-
rugated or turbulent aluminium fins.
They are designed to offer the maximum
heat exchange surface. All batteries are
provided with air bleed pipes and water
7
6
4
3 4
6
5
4
3