To Set The Alarm; Snooze Function - Denver Electronics CR-425 Guide D'utilisation

TO SET THE TIME
Rotate the TIME SET KNOB in the direction indicated by the arrow to flip the minute and
hour digits, when the minute digit reaches 59 then the hour will increase automatically.
Note: Both time and alarm are displayed in 12 hours mode.

TO SET THE ALARM

Rotate the ALARM SET KNOB in the direction indicated by the arrow (clockwise) to select
an alarm time. Please do not rotate the alarm set knob anticlockwise as this can damage
the mechanism and prevent the clock and alarm from working properly. The alarm set dial
shows the hours on the left and the minutes in 15 minutes intervals on the right in the cycle
of 00, 15, 30 and 45.
Switch the ALARM OFF/ON switch to ON to set the alarm and to switch it off when it is
sounding. Use the ALARM select switch to choose buzzer or radio for the alarm.
TO TURN ON/OFF THE CLOCK BACKLIGHT
In normal mode, press and hold the SNOOZE button for 3 seconds to turn on/off the clock
backlight.
It will be off automatically after several seconds.
TO LISTEN TO THE RADIO
1. Press the POWER button to turn on the unit. When the radio is ON, the power LED
indicator will be lit solid red.
2. Press and hold the TUN + or TUN - button to scan the radio station and store it
automatically.
3. Press the TUN + or TUN – button repeatedly to select the radio station stored as step 2.
4. Press the POWER button again to turn off the unit.
VOLUME CONTROL
- When device is in FM mode
Increase the volume by 1 unit by pressing VOL + button.
Long press the VOL + button to increase the volume to the desired unit.
- When device is in FM mode
Decrease the volume by 1 unit by pressing VOL - button.
Long press the VOL - button to decrease the volume to the desired unit.
TO WAKE UP TO RADIO/BUZZER
1. For alarm, set the alarm as previously instructed.
2. After setting the time, slide the ALARM SELECT SWITCH- BUZZER/RADIO switch to
BUZZER or RADIO position to choose to wake up from Buzzer or Radio.

SNOOZE FUNCTION

When the alarm sounds (buzzer or radio) you can switch it off temporarily (for 9 minutes)
using the 'snooze function'. The snooze switch is located in the base of the radio (back left).
Gently press the top of the radio on the left hand side at the back (as you face the radio) to
activate snooze. You can press again to repeat when the alarm sounds again.
ENG-6