Use Of The Product - Beper BP.620 Manuel D'instructions

Vacuum blender Use instructions
VACUUM FUNCTION WITH TUBE :To activate the vacuum function by using the special tube, insert the coffee
grinder provided with blades into the motor housing. Connect the connection of the tube to the motor housing
and the connection of the tube for accessory to the air valve placed on the cover of the travel container (FIGURE
B1). Connect the power cord to the electrical outlet and you will hear 6 beeps and all the display lights will flash
6 times, after which only the ON/OFF button will flash. Press and hold the ON/OFF button until 00:00 appears
on the screen. At this point press ON/OFF again and when the process is complete the write END will appear
on the display.
The vacuum operation with the travel container can be performed either by mounting the travel lid or by mounting
the lid with date indicator.

USE OF THE PRODUCT:

Before using the product for the first time, it is recommended to clean each component following the instructions
in the paragraph "Cleaning and Maintenance".
1. Verify that the anti-splash cover is correctly positioned:
When the symbol " " is positioned next to the symbol " " on the lid of the jar, it means that it is correctly closed.
When the symbol " " is positioned next to the symbol " " on the lid of the jar it means that the lid has not been
closed properly.
2. Insert the food previously cut into pieces and add water / milk according to the recipe, taking care not to
exceed the MAX level indicated on the jar.
3. Place the lid over the jar with the spout slightly to one side and then rotate until it is aligned and close securely.
This operation could be a bit difficult because to make the airtight cover you need to exert a certain pressure.
4. Place the jar on the motor housing, press lightly and turn clockwise until the jar is in the correct position in the
guides placed on the motor housing . The handle of the jar must be to the right of the product.
5. Place the noise reduction cover.
6. Connect the power cord to an electrical outlet and the unit will turn on.
7. Due to the variety of the ingredients, food can inevitably stick to the jar's walls during operation. It is therefore
advisable to stop the appliance, open the anti-splash cover in a clockwise direction and use the supplied pusher
to move the food, then start the processing process again. (Do not use accessories other than those supplied).
Cleaning and Maintenance :
1.Unplug the power cord before cleaning the product;
2.The components must be cleaned immediately after use;
3.The external part of the product can be cleaned with a damp cloth, DO NOT immerse and do NOT rinse the
motor housing, the cable and the plug in water and / or other liquids;
4.The product must be stored in a dry place, avoid direct exposure to ultraviolet rays of the sun;
5.Before storing the product, make sure it is clean and dry.
Technical Data:
Power: 1000W
Power supply: 220-240V – 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
14