Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 2 fitting brackets
- 4 rubber spacers Ø6 L : 5mm
- 2 screws BHc 10×15
- 1 plastic spacer Ø6 L : 15mm
- 2 screws BHc 5×30 (big head)
- 1 screw BHc 6×40 (small head)
- 2 plastic hose joints + 2 pieces of hose 100 mm long
Fitting instructions
- Install both plastic hose joints on the original hoses and place both pieces of hose
100 mm long.
- Screw the fitting brackets on the motorcycle, as shown on the pictures, thanks
to 2 screws BHc 10×15 and steel washers Ø10.
- Place the « silent block » on the rear fitting points of the belly pan. The metal
spacer flange is placed towards the outer part of the belly pan.
- Remove the lower fitting screws from original scoops (see photo).
Original fixing to remove
- Place the left-hand side of belly pan. Fit the front part using one screw 5×30 and one plastic washer, and by
inserting 2 rubber spacers between the belly pan and the original scoops. Fit the rear part with the screw 6×30.
- Place the belly pan right-hand side and proceed as previously to fit the front part. For the rear part, use the
screw 6×40 and insert the spacer between the bracket and the belly pan.
- Pass the hose extensions set up previously through the 2 holes in the belly pan. Pull them as much as
possible not to touch the exhaust pipe, and then cut what is left over by leaving at least 25 to 30 mm.
Location of the piece of seal
to stick.
At right and left.
Once fitted, the belly pan must have no contact with engine and has to be far enough from
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
ADAPTABLE ON BMW S1000R 2014 → ∞
- 2 « silent block » with steel spacer
- 2 pieces of rubber seal L : 3cm
- 2 steel washers Ø10 M type
- 2 plastic washers Ø5
- 1 screw BHc 6×30 (big head)
complet exhaust system
« CAUTION »
FITTING INSTRUCTIONS
ERMAX BELLY PAN IN 2 PARTS
Estimated fitting time : 30 mn
Right-hand side bracket
Left-hand side bracket
Publicité
