ALPATEC RSBE 2400.1 Notice D'utilisation page 7

All manuals and user guides at all-guides.com
notice RSBE 22/05/07 10:21
When the ambient temperature reaches the desired temperature, the appliance stops heating (the visual
display (9) disappear) ; it fans for a few seconds and stops totally (the visual display (8) disappear).
If the ambient temperature decreases and reaches 3°C below the desired temperature, the heater starts
again.
• « Fan » mode: Fan flashes on the screen when this mode is selected.
The appliance fans only (no heating) and the visual display (8) moves on the screen.
UP (6) and DOWN (7) touches are not available in this mode.
• Stop:
In « Low » mode, press MODE touch (4) three times to stop the heater. The appliance will fan only for a
few seconds and then stops.
In « High » mode, press MODE touch (4) two times to stop the heater. The appliance will fan only for a few
seconds and then stops.
In « Fan » mode, press MODE touch (4) one times to stop the appliance.
• Press Main Power Button (6) to shut off completely the heater.
• Unplug the heater if you do not use it for a long time.
This heater is equipped with a timer that can be set from 1 to 12 hours.
• Press Timer touch (5) to set the desired time (each pressure adds 1 hour).
• When the timer is set, countdown will begin after no buttons are pressed for five seconds. The
display will continue to show the remaining time.
• The heater will shut off when the set time has elapsed; the fan motor will continue to run for 10
seconds for the heater to cool down.
To cancel the TIMER mode press the TIMER button until TIMER 0:00 appears on the display.
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a cloth.
• Never use abrasives or detergents.
Page 7
TIMER:
MAINTENANCE
7