Variables Bitfield - Gabotronics Xscopes Manuel

6.2.1 Variables Bitfield

Name Bits
Bit 0: Channel on
Bit 1: x10 probe
Bit 2: Bandwidth limit
CH1ctrl
Bit 3: AC/DC select
and
Bit 4: Invert channel
CH2ctrl
Bit 5: Average samples
Bit 6: Math Active
Bit 7: Math operation
Bit 0: Channel on
Bit 1: Pull
Bit 2: Pull Up
Bit 3: Low
CHDctrl
Bit 4: Invert channel
Bit 5: Serial Decode
Bit 6: Parallel Decode
Bit 7: ASCII Sniffer display
Bit 0: Normal Trigger
Bit 1: Single Trigger
Bit 2: Auto Trigger
Bit 3: Trigger Direction
Trigger
Bit 4: Round Sniffer
Bit 5: Slope Trigger
Bit 6: Window Trigger
Bit 7: Edge Trigger
Bit 0: Roll Scope
Bit 1: Automatic Cursors
Bit 2: Track Cursors
Bit 3: CH1 Horizontal Cursors on
Mcursors
Bit 4: CH2 Horizontal Cursors on
Bit 5: Vertical Cursor on
Bit 6: Reference waveform on
Bit 7: Single Sniffer Capture
Bit 0: Grid 0
Bit 1: Grid 1
Bit 2: Elastic Display
Bit 3: Invert Display
Display
Bit 4: Flip Display
Bit 5: Persistent Display
Bit 6: Line / Pixel Display
Bit 7: Show Settings
XScopes
Notes
For future hardware
For future hardware
For future hardware
Enables math (addition or multiplication)
Subtract (1) or Multiply (0)
Pull resistor enabled
Pull up (1) or pull down (0)
Thick line when logic '0'
The Normal Trigger bit must also be enabled for Single Trigger
Dual Edge Trigger is enabled by clearing bits 5,6,7.
CH1 and CH2 Horizontal cursors are mutually exclusive
CH1 and CH2 Horizontal cursors are mutually exclusive
00: No Grid, 01: Dots per division
10: Follow trigger, 11: Graticule
Line (1), Pixels (0)
DS-XScopes-2.2 - Septembre2012
Manuel
Page | 30