Europe - Eu Declaration Of Conformity; Fcc Caution - Acer ACR010 Guide De Démarrage Rapide

Europe – EU Declaration of Conformity
All manuals and user guides at all-guides.com
We declare under our sole responsibility that
the product is conformity with all the essential
requirements and other provisions of the European
Council Directive RoHS Directive (2011/65/EU), EMC
Directive (2014/30/EU) on issued by the Commission of
the European Community.
This product must not be disposed of with your other
House hold waste or treat them in compliance with the
local regulations or contact your local city office, your
household waste disposal service or the shop where
you purchased the product.
FEDERAL COMMUNICATIONS COMMISSION
(FCC) STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.

FCC Caution

Changes or modifications not expressly approved by the part
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.