Télécharger Imprimer la page

Cannon 1491072 Instructions De Montage

Transducteur digi-troll iv 120khz

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

CAUTION:
READ THIS MANUAL CAREFULLY
BEFORE OPERATING YOUR
NEW CANNON
ACCESSORY.
®
RETAIN FOR FUTURE REFERENCE.
NOTE: Do not return your CANNON
retailer. Your retailer is not authorized to repair or replace
this unit. You may obtain service by:
• calling CANNON
at 1-800-227-6433;
®
• returning your accessory to the Factory Service Center;
121 Power Drive, Mankato, MN 56001
Please include proof of purchase, serial number
and purchase date for warranty service with any
of the above options.
The Cannon
Digi-Troll IV 120KHZ Transducer enables the bottom following option to dect and
®
follow bottom contour changes. The accuracy of your Digi-Troll IV is largely dependant on correctly
installing the transducer on your boat. If not installed properly, your Digi-Toll IV unit will not give you the
service of which it is capable.
The Digi-Troll IV functions by sending a series of sonar pulses from the transducer. Each pluse
travels through the water until it hits the bottom terrain. The pulse then "bounces" back to the transducer
where it is converted to an electical signal and used to adjust the depth of the downrigger weight accord-
ingly.
The face of the transducer must be in intimate contact with undisturbed water. Sonar signals can-
not travel either through open air or through turbulent water. Air and/or turbulence will "blind" the sonar,
causing it to lose bottom contact or otherwise cause poor operation of the bottom following feature. To
ensure that the transducer is mounted properly, follow the suggestions in this manual.
Digi-Troll IV
120KHZ Transducer
accessory to your
®
Mounting Instructions
1491072

Publicité

loading

Sommaire des Matières pour Cannon 1491072

  • Page 1 BEFORE OPERATING YOUR NEW CANNON ACCESSORY. ® RETAIN FOR FUTURE REFERENCE. NOTE: Do not return your CANNON accessory to your ® retailer. Your retailer is not authorized to repair or replace this unit. You may obtain service by: • calling CANNON at 1-800-227-6433;...
  • Page 2 Transom Mounts center of the transom is a must. Mounting suggestions for low and high speed performance are given below. The most common place to mount your transducer is on the transom. It may be helpful to drive your boat Regardless of the operating speed you prefer, at a variety of speeds and observe wher the water flows always remember the face of the transducer should be...
  • Page 3 How to Mount the Transducer To mount the transducer: • Refer to Figure 3. • Use the template as a guide and drill four 9/64”” holes in the transom, 3/4” deep. • Loosely attach the two metal brackets with four #10 self tapping screws pro- 1/8”...
  • Page 4 European Union member state requirements, please contact your dealer or distributor from which your product was purchased. To download product manuals or purchase Cannon products from an authorized dealer, please visit our web page at www.cannondownriggers.com Johnson Outdoors, Inc.
  • Page 5 Instructions de montage Le transducteur Digi-Troll IV 120KHZ de Cannon rend possible la détection du contour du fond et ® les changements automatiques de position du plomb pour suivre ce contour. La précision de votre Digi- Troll IV dépend largement de la bonne installation du transducteur sur votre bateau.
  • Page 6 Montage sur tableau arrière Quelle que soit la vitesse de déplacement que vous pré- férez, souvenez que le transducteur devrait être monté de façon L’endroit le plus commun où monter le transducteur est à ce que sa face soit toujours, si possible, parallèle à la surface sur le tableau arrière.
  • Page 7 Comment monter le transducteur Pour monter le transducteur : • Reportez-vous à la figure 3. • Servez-vous du gabarit comme guide et percez quatre trous de 3,57 mm (9/64 po) dans le tableau arrière, 19,1 mm (3/4 po) de profondeur. •...
  • Page 8 équipement afin de les recycler ou les récupérer et/ou sur les exigences de votre pays membre de l’Union européenne, veuillez con- tacter le concessionnaire ou distributeur de qui vous avez acheté le produit. Pour télécharger les manuels de produit ou acheter des produits Cannon d’un concessionnaire agréé, veuillez visiter notre page Internet à www.cannondownriggers.com.