Uberhaus 38115134 Guide De L'utilisateur page 8

Fig. 6-1: Insert long middle
beam (E2) into middle beam
down tube (E1). Insert F2 into
E1
Fig. 8: Insert curved beam (D)
into curved beam down tube
(H).
Fig. 11: Insert small top
curved beam (J) into small
top connector (K).
Fig. 6-2: Insert hook (M) into
large top connector (I), then
insert long middle beam (E2)
and short middle beam (F2) into
pipe of large top connector (I).
Fig. 9: Insert one side of
curved beam (D) into pipe of
large top connector (I).
Fig. 12: Put small canopy (R)
on small top, then attach four
corners of small canopy to
small top curved beam (J).
Fig. 7: Attach middle beam down
tube (E1) to middle beam down
connector (G) with screw (FF), flat
washer (BB) and nut (EE).
Fig. 10: Attach curved beam down
tube (H) to the U chip of post (A1)
with screw (FF), flat washer (BB)
and nut (EE).
Fig. 13: Attach finial (L) to
small top connector (K) with
flat washer (JJ).