UBERHAUS DESIGN 72255009 Guide De L'utilisateur page 6

5. Attach the Cross Bar (E) to Long Side Lintel (G1/G2) with Bolt (W), then insert the Connection
Tube (L) into Cross Bar (E), attach the assembled Corner Connector (F1/F2) to Cross Bar (E).
Repeat on the other side. Line up the Corner Connector and Cross Bar, then attach with Connection
Piece (K) and Screw (U). Attach the Corner Connector (F1/F2) to Long Side Lintel（ G1/G2） with Bolt
(W), attach the Cross Bar (E) to Short Side Lintel (H1/H2) with Bolt (W). Repeat for the other side.
Hardware Hardware
Hardware Hardware Used
Plastic Cap / Bolt / Washer / Thick
Y
d
C
N2
E
c
B
F1
6. Attach the end of the Long Sliding Tube (N1) to long side of Corner Connector (F1/F2) with Bolt (Y), attach
the end of the Short Sliding Tube (N2) to short side of Corner Connector (F1/F2) with Bolt (Y) (See Diagram a)
Repeat on each corner.
7. Attach the end of the Top Bar (B) to Center Connector (A) (Shown Diagram b); attach the other end of the
Top Bar (B) to Corner Connector (F1/F2) (See Diagram c)
8. Attach the end of the Top Bar (C) to Center Connector (A) (See Diagram b); attach the other end of the Top
Bar (C) to Cross Bar (E) and Sliding Tube (N2) with Bolt (Y) (See Diagram d). Repeat on each side.
9. Attach the end of the Top Bar (C) to Center Connector (A) (See Diagram b); attach the other end of the Top
Bar (C) to Cross Bar (E) and Sliding Tube (N1) with Bolt (Y) (See Diagram d). Repeat on each side.
Used in in in in Step Used Used Step Step 4 4 4 4 Step
Plastic Washer
a
Y
N2
12
Y
N2
E
A
N1
d
Page 6
b
C
Y
N1
E
A