Publicité
Les langues disponibles
Les langues disponibles
5. TIGHTENING YOUR NINJALINE™
Check to make sure you have both ends at the same, correct height.
Step 1: Feed the end of the NINJALINE through the ratchet, taking up
ALL the slack. Make sure the line is not twisted. YOU MUST
line tight before using the
See photo. You should be finished with tightening when you cannot
ratchet anymore. The ratchet should be hidden under the line. YOUR
LINE SHOULD BE TIGHT.
Note: Make sure the line is threaded straight through the ratchet (not at an angle).
Failure to do this will weaken the ratchet and may cause it to break.
FIGURE 5
6. RELEASING THE RATCHET:
To remove or reposition your NINJALINE obstacles OR to take down your line, you will have to loosen your line first!
Step1:To release the ratchet, pullup the vinyl coated gate inside
the ratchet handle and open all the way until FLAT. EXPECT
A"POP"
Step2:The second release gate should open, releasing the spool and
the line tension should "pop" open with NINJALINE releasing.
Step3: Continue to pull on the line till there is little tension left. You can
now reposition or remove your obstacles.
Slide the remaining line out of the ratchet.
Note: To release all gates, open ratchet flat.
Webbing will be free to unwind.
MANDATORY LOAD STRESS TEST
Step 1: Make sure all your connections are tight –
See INSTALLING YOUR NINJALINE™ section
Step 2: MANDATORY LOAD STRESS TEST YOUR
LINE.
Using either a 250 LBS(113kg) weight or
person, have them test the NINJALINE™ by
suspending the weight 5 feet(152cm) from each end.
Step 3: Keep your course clear - Bystanders should maintain a safe distance from the line 10ft (3.1m) to
prevent impacts by person's jumping down from the line. If you are unsure about your health for NINJALINE™,
please consult with your doctor before attempting.
b4 Adventure 4010Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
ratchet. The ratchet should befacing down.
FIGURE 6
info@b4Adventure.com ·
www.b4adventure.com
Pull the
FIGURE 8
303-339-0482 -
DC:080818
FIGURE 4
FIGURE 7
FIGUR
4
Publicité
