Victron energy Blue Power IP65 Serie Manuel D'utilisation page 5

checked regularly. If the water level is low add distilled or
demineralised water.
• This appliance is not designed for use by young children or
people who cannot read or understand the manual unless they
are under the supervision of a responsible person to ensure that
they can use the battery charger safely. Store and use the battery
charger out of the reach of children, and ensure that children
cannot play with the charger.
• Connection to the mains supply must be in accordance with the
national regulations for electrical installations.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similary qualified persons in
order to avoid a hazard.
• Never try to charge non-rechargeable batteries.
3. Charging
1. Connect the charger to the battery.
2. Connect the charger to the wall socket. The CHARGE LED will
indicate that the mains cable is connected to the wall socket.
The charge status LED's will blink in case of reverse polarity
connection, short-circuit or if a 12 V charger is connected to a
24 V battery.
3. Press the MODE-button to select a charging program.
The charger will remember the mode setting and start in the
same mode the next time it is used.
4. The battery is fully charged when the READY LED is on,
simultaneously with the FLOAT or STORAGE LED.
5. Stop charging at any time by disconnecting the mains cable
from the wall socket.
3