Safety Instructions; Transport, Placement And Installation; Transport Using Lifting Equipment; Conditions For Placement - Denios VarioTwin Serie Mode D'emploi

Original
User Manual

Safety instructions

2
 Refrain from any unsafe working practices.
 Observe the applicable rules for health and safety at work.
 No fire, naked flames or smoking.
 Packaging and containers must meet the transport regulations.
 Only store materials for which the sump is designed.
 Do not exceed the load capacity of the sump.
Store materials so that all containers and the sump are visible.

If flammable substances are to be stored, the user must carry out a risk assessment, to
sets out the measures to be taken to prevent hazards in accordance with ATEX guide-
lines.

Transport, placement and installation

3
3.1

Transport using lifting equipment

Transport the sump only when empty.
The sump can be lifted and transported from four sides by a forklift truck or a pallet truck.
3.2

Conditions for placement

The sump must only be assembled on even, paved surfaces. The sump is designed for indoor use. If it is
to be used outdoors, arrangements must be made to ensure that rainwater, snow or hail cannot penetrate
either into or underneath the sump.
3.3

Fitting the grids (optional)

Slot in the grid brackets, if necessary pushing out the edge of the sump gently using a hammer or rub-
ber mallet. Position the central support (if used). Lay the grid onto the brackets. Make sure the grid is
evenly positioned from the edge of the sump.
For type TW 203-L and TW 208-L sumps, secure the grids and supports with the supplied fasteners.
(see Figs 3.3.-1 to 3.3.-3 - next page)
217882_BA_VarioTwin_001_INT
WARNING
NOTE
Page 11 of 28
25.06.13