FBS 50300 FPV Manuel

Instructions for Use – Manual Operation
• Fill the bottle up to the "Max" indicator.
• Insert pump assembly into the bottle, and screw-on very
tightly, so the seals can maintain su cient pressure.
• Extend pump plunger and stroke 20 – 30 times.
• For spraying, press the trigger. Slowly turn the nozzle to
adjust spray pattern from ne mist to jet.
• Always release pressure in the unit before storage.
• Immediately after use, clean the pump sprayer with clear
water.
• Occasionally lubricate the pump barrel with a few drops
of light oil.
Warranty
Sprayers carry a limited Warranty, which is limited to replacement of
defective part(s) only. Damage attributable to improper use, faulty
maintenance, the effects of chemicals or normal wear and tear
(Seals/o-rings) is excluded from the Warranty.
If defective, the sprayer(s) should be returned to FBS for examination with
transportation prepaid. If defects are covered by the Warranty, the least
expensive inbound/outbound charges will be borne by FBS/Manufacturer. All
returned and repairable sprayers not covered by the Warranty will be repaired/
reconditioned according to the repair fee/schedule, and charges borne by the
customer.
For more information visit our web site at
and consult with FBS for chemical compatibility before using the
sprayer.
www.fbsdistribution.com
Compressed Air Sprayer
50300 FPV/FPE Model
175 Packing (1)
174 Brass Nozzle
173 Nozzle "Fan Jet"
172 O-Ring 5.0 x 1.5
171 Short Swirl Piece
168 Filtre
167 Suction Tube
166 Bottle O-Ring 36.0 x 4.0
165 Screw Cap
164 Valve Spring
163 Valve Plunger
162 O-Ring 3.0 x 2.7
161 Pump Cylinder
150 Retaining Disk
140 Plastic Ball
130 Clip
120 Pump Handle Guide
110 Plunger
100 Screw
90 O-Ring 5.0 x 1.5
80 Plunger O-Ring 14.0 x 3.5
70 Pressure Spring 3 bar
60 Spring
50 Swirl Cone
40 Trigger
20/30 Pump Handle with Lid
10 Sprayer Cup
Manufactured in Germany
FBS Distribution Co., Inc.
www.fbsdistribution.com
Manual