System Setup; Transmitter Setup - LD Systems MEI1000 Mode D'emploi

SYSTEM SETUP:

8

TRANSMITTER SETUP:

1
2
3
4
5
Select Group and Channel:
Repeatedly press the "SET" button until "GROUP SELECT" appears.
Press or to select a suitable frequency group number, as
shown in diagram on the left. Then press "SET" again until
1
"CHANNEL SELECT" appears, as shown in diagram
Press or to select a suitable channel.
Note:
When using multiple systems, for optimum result set all
of the systems to the same group number and select a different
channel number for each system in that group.
Working Mode Selection:
Repeatedly press the "SET" button until "MODE SELECT" appears,
press or to select Stereo or Mono, as shown in diagram
Tune frequency
Not applicable for MEI1000
To exit Setup:
Repeatedly press the "SET" button until "EXIT SETUP" appears.
Press or to exit setup.
Locking Selection:
Repeatedly press the "SET" button until "LOCK SELECT" appears,
press or to select lock or unlock, as shown in diagram
When "LOCK SELECT" is activated settings in the transmitter can
be viewed but not changed.
on the left.
2
.
4
.
3
.
5