Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS Continued
PART 2: ATTACH SCREW STUD TO SURFACE
(E)
(A)
(E)
WARNING! This product contains one or more chemicals known to the state of California to cause
birth defects and other reproductive harm and/or cancer.
These tools are not intended for extensive commercial or industrial use. Using them in
this manner for an extensive period may result in property damage or personal injury.
Manufacturer assumes no responsibility for any product failure due to improper use
or use inconsistent with these instructions.
Made in China
©2017 Arrow Fastener Co., LLC
Arrow and GSSFK6 are trademarks of Arrow Fastener Co., LLC
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, New Jersey 07663
www.arrowfastener.com
For the GSSFK6 manual translation in French and Spanish please visit www.ArrowFastener.com
Pour le manuel de GSSFK6 traduit en Français et en espagnol veuillez visiter www.ArrowFastener.com
Para el manual de GSSFK6 traducido en francés y en español por favor visite www.ArrowFastener.com
GSSFK6
TM
SCREW SNAP FASTENER KIT
STEP 1
Mark and drill hole 1/8" into solid surface for
Screw Stud (E) installation.
STEP 2
Using a Phillips-screwdriver or drill bit insert
Screw Stud (E) into pre-drilled hole.
STEP 3
Snap Button/Cap (A) to Screw Stud (E) to assure
proper fastening.
PRODUCT WARNINGS:
Wear Safety Goggles. The failure to do so may result in
personal injury. To avoid personal injury, always wear
OSHA/ANSI approved eye protection (goggles, face
shield) when using tools.
PMGSSFK6-8n Rev 1216
Publicité
