WorkPro 19225000 Guide D'utilisation page 3

2. CHANGING THE BIT CARTRIDGE
Removing Bit Cartridge
Push the bit cartridge from the right side of the screwdriver so that the cartridge slides out from the body
of the screwdriver.
Installing Bit Cartridge
1. Align the D-shape on the back of the bit cartridge
with the gap in the left hand side of the screwdriver
so that the arrow is horizontal.
Note: Do not force the cartridge into place. If it doesn't slide in easily try realigning by repeating step 1.
3. LOADING A DRIVER BIT
Selecting Driver Bits
Note: The bit cartridge must be already installed in order to select a driver bit.
1. Look through the bit view window
to see the selected driver bit.
Loading Driver Bits
1. Press down on the
loading switch
2. Slide the switch forward so that the bit is
pushed into the bit holder
2. Push the cartridge into the screwdriver until it
clicks into place
2. Rotate the cartridge until the required driver
bit is seen through the view window.
Unloading Driver Bits
1. Press down on the
loading switch
2. Slide the switch backward so that the bit
retracts from the bit holder