Robert Bosch GRW 9 Mode D'emploi page 6

EURO • Printed in Germany • BA 3 609 929 353 • GRW 9 • GB • OSW 05/00
GRW 9 - GB Seite 7 Freitag, 26. Mai 2000 10:40 10
Product Specification
Agitator
Part number
Rated power
Speed under load
No-load speed
Driving spindle
Spindle neck diameter
Weight
(without optional extras) approx. 3.0 kg
Safety class
Noise/Vibration Information
Measured values determined according to
EN 50 144.
The A-weighted noise levels of the machine are
typically: sound pressure level: 85 dB (A); sound
power level: 98 dB (A).
Wear ear protection!
The typical hand/arm vibration is below 2.5 m/s
Intended Use
The machine is intended for stirring powder-type
building materials such as mortar, plaster, ce-
ment, and solvent-free paints, varnish and similar
substances.
Machine Elements
1 Stirring paddle
2 Adapter
3 Drive spindle
4 Spindle collar
5 Spray guard
6 Ventilation slots
8 On/Off switch
9 Handle
10 Handle tightening nut
11 Clamping lever
12 Auxiliary handle
Not all of the accessories illustrated or described are
included as standard delivery.
GB
GRW 9
0 601 968 0..
900 W
0 – 400 RPM
0 – 500 RPM
5/8"
43 mm
/ II
2
.
Always direct the cable to the rear away from
the machine.
Always switch off the machine and allow to
come to a stop before placing it down.
Insert the mains plug only when the machine is
switched off.
Use the machine only with the auxiliary han-
dle 12 .
If the machine should fall into the substance to
be stirred, immediately pull out the mains plug
and have the machine over-hauled by the cus-
tomer service.
Never allow children to use the machine.
Do not treat explosive substances (e. g. easily
inflammable solvents) and materials with a
combustion point below 21 °C. Observe the
processing instructions of the manufacturer.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
Bosch can assure flawless functioning of the
machine only when original accessories are
used.
For Your Safety
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein
strictly followed.
In addition, the general safety in-
structions in the enclosed book-
let must be followed. Before us-
ing for the first time, ask for a
practical demonstration.
If the mains cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Wear protective glasses and ear
protection.
For long hair, wear hair protection.
Work only with closely
clothes.
are
fitting
7