Publicité
Les langues disponibles
Les langues disponibles
HDMI OVER IP EXTENDER
BY NETWORKING CABLE
Quick Installation Guide
All brand names and trademarks are properties of
their respective owners
PRODUCT OVERVIEW:
Transmitter:
Power Status
HDMI Input
5V/DC
● IR Out: plug the IR blaster into this jack
● IR In: plug the IR receiver into this jack
● HDMI Input: connect to the HDMI output of your HDMI source device
● Status: this LED illuminates to indication the status of this transmitter
● Power LED: this LED illuminates when power is applied to the transmitter.
● Reset: press and hold this button for about 10 seconds to reset the transmitter
to the factory default settings
● DC/5V: plug one of the included AC power adapters into this DC jack
● Ethernet: connect a cat5e/6 Ethernet cable into this port to deliver the signal
to the receiver
IR In
IR Out
Ethernet
Reset
INTRODUCTION:
This HDMI over IP Extender use the advanced M-JPEG as the compression
type, which makes it occupy lower bandwidth and transmit over the LAN more
smoothly.
It supports 120m over single cat5e/6 cable at point to point, as well as point to
many over Ethernet switch.
The over IP solution is widely used in various locations, like meeting room, class
room, metro, airport, home, mall advertisement...etc.
FEATURES:
● Using M-JPEG compression encoding, support resolution up to 1080p@60hz
● Comply with TCP/IP protocol, Transmit up to 120meters@1080p/60Hz over
single Cat5e/6 cable
● Support LPCM audio format
● Bi-direction Wide-band IR pass through to control the source or sink device.
(38khz to 56khz)
● Support one to one or one to many modes with large cascade
● HDCP Compliant
● Support PC web control
● Build in EDID
● Carry power to Tx and Rx units with a Power Over Ethernet enabled Smart
Managed Switch (*Optional POE version only)
PACKAGE CONTENTS:
● 1x Main unit Transmitter
● 1x Main unit Receiver
● 2x IR-Receiver cable
● 2x IR-Blaster cable
● 1x User Manual
● 2x 5V Power adapter
1
Receiver:
Power Status
5V/DC
● IR Out: plug the IR blaster into this jack
● IR In: plug the IR receiver into this jack
● HDMI output: connect to the HDMI input of your HDMI sink device
● Status LED: this LED illuminates to indication the status of this receiver
● Power LED: this LED illuminates when power is applied to the receiver
● Reset: press and hold this button for about 10 seconds to reset the receiver to
the factory default settings
● Ethernet: connect a cat5e/6 Ethernet cable into this port to receive signal from
the transmitter
● DC/5V: plug one of the included AC power adapters into this DC jack
3
HDMI Output
IR In
IR Out
Ethernet
Reset
2
4
Publicité
