Publicité
Les langues disponibles
Les langues disponibles
7. Because of limited space, unscrew the junction box
from the locating tabs below the firebox, then plug in
the light receptacle, and then reattach the junction box
to the locating tabs. See Figures 5 and 6.
35823-1-0220
Figure 5
Figure 6
Empire Comfort Systems Inc. • Belleville, IL
8. Set the magnetic rheostat base on the fireplace floor,
inside of either of the shaded areas shown in Figure 3
on page 2. If a FBB14 blower accessory is being
fitted, the light rheostat will have to sit on the left.
9. Turn on the light and observe where the light is being
cast. If desired, bend the light shields outwards
as shown in Figure 7 in order to allow the light to
illuminate the entire firebox floor. Note that if the
shields are bent outwards too far, light will be cast
upon the barrier screens and may create undesirable
"streaks."
10. Replace the glass and screen frames, and the lower
access panel.
Figure 7
Page 3
Publicité
