Elektron IM600 Notice D'installation page 7

III. Insert the anchor bolts and screw the bracket onto the anchor bolts with the two position
indicators on the top towards the user.
IV. Install the detector on the hooks of the triangular bracket. The tamper switch is pressed against
the bracket in this manner. The four angular arrangements are not necessary unless the
triangular bracket is used for corner mounting.
V. Tighten the bottom fixing screw.
<NOTE>

Be careful to perforate in the thin, pre-cut areas.
Installation
Choose the position of the detector, i.e. either in a corner or on a surface.

After having selected the installation site, follow the previous described above to mount the detector.

Press the Test button to enter Test mode. Walk in the protected area and observe when the LED lights up to check that

the detection coverage is adequate.
Installation is complete when the detection coverage is appropriate.

Installation advice
To optimise performance, the detector must be mounted at a height of 1.9~2.0 m. Has a maximum range of 12 metres when the
microwave sensor is set to maximum range and mounted at a height of 2 metres.
<IMPORTANT NOTES>

In order to optimise performance, remember to adjust the mounting height of the detector according to the height of
the tallest pet. The detector must be mounted in much higher save position in case of large pet.

Remember to take blind spots into consideration to define the height of the mounting point of the detector. The blind
sport under the detector grows proportionally to the height of the mounting site.

It is important to note that performance is influenced by external factors, such as height of the detected object,
required detection range, installation area, etc. The recommended mounting height may be adjusted according to the
actual environmental factors in the installation site.
It is advised to install the detector in the following positions:

Mount it where pets cannot access the detection area by climbing on furniture or other objects.

Avoid pointing the detector to stairs which can be climbed by pets.

Mount it in a position in which an intruder would normally cross the field of vision of the detector.

Mount it in a corner to have the widest view possible.

Mount it where the field of vision is not obstructed, e.g. by curtains, ornaments etc.

Restrictions

Do not position the detector directly facing a door protected by the door contact because the wireless signals of the

door contact and of the detector could be transmitted in input at the same time, causing a conflict of signals.
Do not install the detector fully exposed to direct sunlight.

Do not install the detector in areas in which devices which could cause sudden changes of temperature in the

detection area are present, such as air conditioning units, radiators etc.
Avoid large size obstacles in the detection area.

Do not point the detector directly towards source of heat, such as fires or boilers, and do not install over radiators.

Avoid moving objects in the detection area, i.e. curtains, soft furnishings etc.

Technical specifications
Power supply: 1 lithium battery CR123A 3V

Battery life: 4 years (typical value, may vary according to use)

Two-way radio frequency: 868 MHz

Microwave frequency: 10,525 GHz

Detection range: max 12 m with 110° angles

Working temperature range -10°C to +45°C

Dimensions: 63.3 mm x 112.5 mm x 62 mm

Weight: 100g

Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR DUAL TECHNOLOGY DETECTOR IM600 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.elkron.com
DS80IM39-001C
SIMPLIFIED EU DECLARATION OF CONFORMITY
Bottom Fixing
Screw
7