Operating Instructions; Throttle Control - Enerwatt MOTO M3 Guide D'utilisation

FLAT TIRE REPAIR
6. Check to make sure that the tire is evenly seated around both sides of the rim and that the tube is inside the tire beads.
Push the valve stem into the tire to make sure that its base is seated within the tire beads.
Inflate the tube slowly to the recommended pressure on the tire while ensuring that the tire beads remain on the rim.

OPERATING INSTRUCTIONS

USING THE KEY AND THROTTLE
ON/OFF/LOCK Switch (ignition):
1. Turn the scooter ON when you are ready to go. Turn it OFF
when you are not driving and remove the key.
2. Turn the scooter OFF when not in use to preserve the battery.
3. Turn the key to this position to lock the handlebar and turn towards the lock.
4. Handlebar is locked. The key can be removed.
CAUTION
BEFORE USING YOUR MOTO M3, MAKE SURE THAT THE THROTTLE IS NOT ROTATED
TO THE "ON" POSITION. ALSO ENSURE THAT YOUR THROTTLE IS NOT "STICKY" AND ROTATES
FREELY BACK TO ITS ORIGINAL POSSITION (SEE EXAMPLE BELOW).

THROTTLE CONTROL

The Moto M3 speed changing throttle can be found on the right side of the handlebar.
Rotate the throttle grip towards the seat to accelerate and rotate forward away from the seat to slow down.
LEFT
After accelerating, we suggest you reduce the throttle by ¼ to increase your range and battery life.
(CONTINUED)
EWB-MOTOM3-BK
Moto M3 XPa and XPc
control switches
and throttle
RIGHT
Moto M3 XPh
control switches
and throttle
USER'S MANUAL
22