Publicité
Les langues disponibles
Les langues disponibles
Tools
- hand drill
- 9,5 / 10 mm drill diam. (supplied)
- 3mm wrench or allen screwdriver
Fitting kit
- 2 tall M5 rubber inserts
- 2 M5x25 BHC alu black screws
Assembly
- Place the screen on the nose fairing and center it. Make sure to leave a uniform space (3 to 10 mm)
between the fly screen and the nose fairing (photo 1).
- Mark the fitting holes with a soft lead pencil.
You can stick a paper adhesive tape (masking type) beforehand and use a pen or a felt-tip pen.
- Bore carefully the nose fairing in with the supplied drill (photo 2).
BE CAREFUL NOT TO EXCEED TOO MUCH THE THICKNESS OF THE COVER,
AT THE RISK OF DAMAGE TO THE CABLES OR THE DASHBOARD!
Remove the paper tape if necessary. Deburr carefully.
- Paste the rubber stamp in the axis of symmetry (photo 3).
- Place the 2 inserts in the 2 holes up to the stop, then fix the fly-screen with the 2 screws and 2
washers (photo 3). Check the outfit.
Have a good trip !
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
FITTING INSTRUCTIONS
SUITABLE FOR ZONTES 125 SCRAMBLER
- 1 tall self-adhesive rubber stamp
- 2 L5 plastic washers
ERMAX FLY SCREEN
« CAUTION »
Date : 18/03/2022
Publicité
