Norton Kp 200 Mode D'emploi page 5

Precautions and useful tips
CLIP: Never put your amplifier in saturation mode (or in CLIP).
The clip is indicated by LEDs ( on Front View. Occasional flicker of these LEDs
indicate normal maximum output power. If LEDs light on continuously this may
cause serious damage to the speakers.
SPEAKERS: Use speakers adapted to the output power of the used amplifier.
Never use speakers with impedance below 4 ohm.
Always respect the indicated polarity (see Rear View)
In case of intensive use, an extra ventilator might be necessary.
No user parts inside.
In case of a technical defect, please consult your dealer.
Installation Instructions
In order for your amplifier to give full satisfaction, please follow these precautions:
1 - Never do not expose to rain or damp environment.
2 - Avoid violent shocks. They may cause serious damage to the electronics.
3 - Place in a ventilated location.
4 - Required Power source: 220/230V AC 50Hz.
5 - Before switching on, make sure the volume controls ( and 1 2
on Front View)
are turned down.
6 - Switch on the amplifier with ON/OFF switch ( on Front View ). 5
7 - Turn on the volume control progressively.