Publicité
Les langues disponibles
Les langues disponibles
MOUNTING IN DECP-1X4 ONE RACKSPACE PANEL
• Use (2x) thumb nuts (H) to mount your remote power switch to pre-installed studs inside the panel.
(FIGURE D)
Pre-Installed
6-32 Studs
INSTALLING THE PIGGY BACK POWER CABLE
1. Install piggy back power cable (J) into properly rated receptacle as shown. (FIGURE F)
2. Plug the power cord from your controlled equipment into the back of the piggy back power cable.
WARRANTY
For warranty information, refer to http://www.middleatlantic.com/company/about-us.aspx#warranty
Corporate Headquarters
Corporate Voice: 973-839-1011 - Fax: 973-839-1976 / International Voice: +1 973-839-8821 -
Fax: +1 973-839-4982
www.middleatlantic.com - info@middleatlantic.com
Middle Atlantic Canada
Voice: 613-836-2501 - Fax: 613-836-2690 / ca.middleatlantic.com -
customerservicecanada@middleatlantic.ca
Factory Distribution
USA: NJ - CA - IL Canada: ON - BC
At Middle Atlantic Products we are always listening. Your comments are welcome.
Middle Atlantic Products is an ISO 9001 and ISO 14001 Registered Company.
C
H
FIGURE E
DECP-1X4
FIGURE F
J
Page 8
Controlled
Equipment Power
Cable
Publicité
