Sport-thieme Countdown Manuel page 4

Anleitung
zu Art.-Nr. 281 9105
Stopwatch setting
The digits on upper two rows show the lap counter and split time (accumulated time since the start of the event) or show lap time
(the interval of time since the last reading) .The digits on the bottom row display the current running time. Entering stopwatch
resetting mode, press [C] key to select the second row to display "SPLIT time" or "LAP time" memory.
Stopwatch mode
In stopwatch mode, press [A] key each time to start or pause stopwatch, each press [B] key to recall one data under running
mode. In pause state, press [B] key to clear the data.
Memory recall
Press [C] key to enter the recall memory status, display" RECALL" on screen, each press [C] key to display "FS" fastest time and
the lap counter → "SL" slowest time and the lap counter → "AV' average time and saved lap counter. Each press [C] key to review
the memory in ascending order. After finish review, press [D] key to exit memory recall status. Countdown mode
"TIMER" symbol will be shown on display under countdown time mode. The first and two row shows "finished countdown times"
and " preset countdown time". The bottom row shows the running countdown time.
Setting countdown time
In countdown mode, keep pressing [C] key for 2 second to enter the countdown setting."Hour" starts to flash, each press [B] key
at that time, switch between"Hour→ minute → second" successively, when the number starts to flash, each press [A] key to add
"1", keep pressing to add rapidly. After finish setting, press [C] key to exit countdown.
Start or pause countdown
In countdown mode, each press [A] key to start or pause countdown. In the pause status, press [B] key to reset countdown, clear
the countdown. After the countdown time is finished one time, the counter will add "1" and there is warning tone, when the times
reach 9999, the countdown will stop and the times is cleared.
Low battery indication
When low battery, the interface starts to flash and display
meantime make sure the positive and negative polarity of the battery is installed correctly.
Reset factory settings
If the stopwatch is crashed or find something unusual, please press and hold [ABCD] keys for 2 second simultaneously to restart
it. After restart, all data is reset.
IV Maintenance
· When low battery, please replace with a new one timely (CR2032) and make sure it will be installed correctly.
· Keep away from prolonged exposure to hot sun or high temperatures to avoid darkening
· Keep away from sharp hard objectimpactand corrosive liquid, so as not to damage the stopwatch.
The executive standard No.: GB/T22778-2008
! battery and physical damage is exclude.
, please replace the battery timely (oell battery is CR2032),
4