Toa N-8000AL Manuel D'installation
  1. Manuels
  2. Marques
  3. Toa Manuels
  4. Équipement d'enregistrement
  5. N-8000AL
  6. Manuel d'installation
Toa N-8000AL Manuel D'installation

Toa N-8000AL Manuel D'installation

Masquer les pouces
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Télécharger ce manuel
TELEPHONE INTERFACE UNIT
TABLE OF CONTENTS
1. SAFETY PRECAUTIONS ............................. 2
2. GENERAL DESCRIPTION ........................... 4
3. FEATURES ................................................... 5
Front .............................................................. 5
Rear ............................................................... 5
5. INSTALLATION ............................................ 6
5.1. Equipment Rack Mounting ...................... 6
5.1.1. Setting space ................................. 6
5.1.2. Mounting on the rack .................... 7
5.2. Desk-Top Installation .............................. 8
5.3. Wall Mounting ......................................... 8
Thank you for purchasing TOA's Telephone Interface Unit.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
INSTALLATION MANUAL
6. WIRING ....................................................... 10
6.1. Connection Diagram ............................. 10
6.2. Type of Cable ....................................... 11
6.3. Connector Connection ......................... 11
7. ACCESSORIES .......................................... 12
8. OPTIONAL PRODUCTS ............................ 12
N-8000AL

Publicité

Table des Matières
loading

Sommaire des Matières pour Toa N-8000AL

  • Page 1: Table Des Matières

    5.1.2. Mounting on the rack ....7 5.2. Desk-Top Installation ......8 5.3. Wall Mounting ......... 8 Thank you for purchasing TOA’s Telephone Interface Unit. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.

  • Page 2: Safety Precautions

    • Should the following irregularity be found during or personal injury. use, immediately disconnect the power supply plug from the AC outlet and contact your nearest TOA · Install the equipment rack on a stable, hard floor. dealer. Make no further attempt to operate the unit...
  • Page 3 · The supplied rack-mounting screws can be used injury and/or property damage. In addition, the for the TOA equipment rack only. Do not use them object itself may fall off and cause injury and/or for other racks.

  • Page 4: General Description

    2. GENERAL DESCRIPTION TOA's N-8000AL is Telephone interface unit used for the N-8000 Series Packet Intercom System (IP network compatible intercom) employing packet audio technology*. It has a single telephone line interface, allowing an analog telephone to be connected.

  • Page 5: Features

    3. FEATURES • Exchanges, IP stations and various kinds of interface units can be distributed over a data communications network. • Can be connected to an existing local area network (LAN) or wide-area network (WAN). • The dedicated software program enables centralized control with a personal computer. •...

  • Page 6: Installation

    5. INSTALLATION The N-8000AL can be installed in any of three ways: Equipment rack mounting, Desk-top installation, and Wall mounting. 5.1. Equipment Rack Mounting A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient.

  • Page 7: Mounting On The Rack

    Component parts of MB-15B-BK Composants du MB-15B-BK Tapping screw 3 x 14 Vis-taraud 3 x 14 Tapping screw 3 x 8 Vis-taraud 3 x 8* N-8000AL Blank bracket Patte vierge Tapping screw 3 x 8 Vis-taraud 3 x 8 Rack mounting bracket...

  • Page 8: Desk-Top Installation

    5.2. Desk-Top Installation Installation sur un bureau When installing the N-8000AL on a desk, secure the supplied plastic feet to the unit’s bottom using the supplied machine screws. Pour installer l’unité N-8000AL sur un bureau, installez les pieds en plastique fournis sur le fond de l’appareil à...
  • Page 9 Step 2. Mount the N-8000AL on the wall. Notes • Use appropriate screws for the construction of wall. • Wood screws 3.5 x 20 are supplied with the YC-850. • The socket-outlet shall be installed near the equipment and the plug (disconnecting device) shall be easily accessible.

  • Page 10: Wiring

    • The apparatus shall be connected to a main socket outlet with a protective earthing connection. • Do not defeat the Class I product's earthed connections. • The interconnected telecommunication terminal equipment (via "TELEPHONE"-connecter of N-8000AL) should be UL Listed and the connections shall be made in accordance with Article 800 of the NEC.

  • Page 11: Type Of Cable

    Outside diameter: ø 1.05 mm or below 6.3. Connector Connection Connect the mini-clamp connector supplied with the N-8000AL to a cable using a commercially available tool (pliers). Cover (transparent side) Step 1. Cut off two-cable ends in equal length, and insert them securely to a cover section (transparent side) of the mini-clamp connector.

  • Page 12: Accessories

    Wall mounting bracket: YC-850 Version update information • Download our TOA Products Data, web site (https://www.toa-products.com/international/) to get the up-to-date version for N-8000 software, firmware, and Instruction manuals. • The software version number can be confirmed using the Help menu.

Table des Matières