Kreg Micro-Pocket KPHA730 Manuel page 4

Assembly/Setup
a. Remove existing drill guide from the Kreg Jig 720 by squeezing the tabs
(1) on both sides and lifting forward and up to remove the drill guide from
the carriage of the Kreg Jig 720.
b. Insert the Micro-Pocket Drill Guide (A) into the carriage by squeezing
the tabs (1) on both sides of the drill guide carriage, inserting the bottom
tab of the Micro-Pocket Drill Guide (A) into the slot on the carriage and
pressing the top of the Micro-Pocket Drill Guide (A) into place.
The following steps are the same as using the standard size drill guide. See
Owner's Manual for detailed instruction on the following steps.
4
1
A