Evenflo Gold Revolve 360 Mode D'emploi page 82

11. Grab Base near belt path as shown
and pull side to side and front to
back to make sure Base is installed
tightly. Base should not move more
than 2.5 cm (1 in) side to side or
front to back at the Belt Path on the
Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
LATCH/UAS strap a little more, and
try again. If Base still moves too
much, you may need to try a different
vehicle seat location, installation
method, or both.
82
LATCH/UAS (Rear-Facing and Forward-Facing)
Installing LATCH/UAS