Learn To Use The Walkingpad - Skandika WalkingPad Mode D'emploi

4. Learn to use the WalkingPad

1. Mode instruction
Standby Mode
Standby mode LED is on;
Motor and sensor stop responding.
Manual Mode
Manual mode LED is on;
Speed can be controlled via remote
control or APP.
Automatic Mode
Automatic mode LED is on;
Speed is automatically controlled by
intelligent algorithm.
It follows the speed of walking - this
means, the faster you walk or run, the
faster the speed of the device will be.
If you slow down your steps, the
device will automatically lower the
speed.
09
2. Standby mode instructions
Standby Mode
In Standby mode, motor and sensor
are not responding to prevent acciden-
tal movements and possible injuries.
Mode Switch
Short press: return to the previous mode.
3. Manual mode instructions (primary mode)
Manual Mode
In this mode, the speed of the WalkingPad can be controlled by the remote
control. Beginners should use the manual mode for their first workouts and
the automatic mode later on only, after being skilled in using the Walking-
Pad. Press the START/STOP button of the remote control in manual mode
to start or stop the WalkingPad.
ACCELERATION
Short press: increase speed by 0.5 km/h.
START/STOP
Short press: Start or Stop the WalkingPad.
DECELERATION
Short press: reduce speed by 0.5 km/h.
MODE SWITCH
Short press: switch to automatic mode.
Long press: switch to Standby mode.
Entering this area in
manual mode will
start the WalkingPad
automatically with a
target speed default
setting of 3 km/h.
10