OPERATING INSTRUCTIONS
This humidifier can be used 2 ways – manual fill or continuous filling from water
source.
1/ MANUAL FILL
- Ensure unit is not plugged into mains when filling with water – switch off und unplug.
- Place unit on a smoth level surface that can support the unit when filled with water.
Lift and remove the top small cover.
- Fill with DISTILLED water if you are in hard water area. DO OT use hot water. DO
NOT add fragrance and oil to water – it will cause unit to malfunction.
NOTE : The unit has wheels due to the weight when filled. Pleased use the wheels
and do not carry the unit. CAUTION : when unit is filled it is very heavy.
- Plug in power source and press the Power button – the power on indicator will
illuminate (Green).
- To adjust mist intensity, turn the control knob clockwise to increase and anti clockwise
to decrease.
- If the red indicator light illuminates after powering on, either the unit is out of water
or the tank is not properly aligned.
- Use the multiway directional nozzle to help wapour dispel. Ensure vapour is directed
away from walls and furniture.
- Pay attention to the water level – add water when low (Red indicator light illulinates
when water is out).
2/ CONTINUOUS FILLING
- If you are in a hard water area it is advised that you run the water via an RO
machine. Connect the automatic top up valve to the outlet from your RO machine.
- Connect your continuous water source. DO NOT turn on until process is completed.
- Lift the openings of the humidifier lid and screw in your automatic top-up valve.
- Use the outlet from your water source to connect to the auto top-up valve inside the
humidifier.
- Turn on your continuous water source.
MANUAL
CONTINUOUS