TooQ TQAPOLO-500SP Guide De L'utilisateur page 12

• Connector MOLEX
• Connector FDD
Power supplies are intended to be installed by professional staff or technical service.
Basic guidelines for installation and started:
1. Following the instructions on the PC case, open it and remove the previous power
supply by disconnecting all the connections and removing the screws that secure the
power supply to the PC. Then place the new power supply in the same place.
2. Locate and connect the ATX, 20 or 20+4 pin main connector on the motherboard. If the
motherboard has only 20 pins, separate the additional 4 pins.
3. Perform the same process with the secondary cable that supplies an additional 12V.
This cable usually has 8 pins (4 + 4), but only four may be required depending on the
type of motherboard.
Pin Description Color
1 +12.0V Yellow
2 COM Black
3 COM Black
4 +5.0V
Pin Description Color
1 +12.0V Yellow
2 COM Black
3 COM Black
4 +5.0V
12
Red
Red