Publicité
TECHNICAL SPECS
INPUTS
INPUT:
Impedance 500 Kohm/ maximum voltage 9 Vpp
EFFECT RETURN:
Impedance 33 Kohm/ maximum voltage 10Vpp
(send/return wired in parallel)
CONTROLS
GAIN:
-46 to 23dB range
MASTER VOLUME
2-WAY SWITCH
FLAT/OLD
LIMITER
ON/OFF SWITCH
GROUND LIFT
(switch on rear panel)
PRE/POST EQ
(switch on rear panel)
EQUALIZATION
LOW:
center frequency 80 Hz; level ±16 dB
MF LOW:
Level ±16 dB (freq: from 100Hz to 800Hz)
MF HIGH:
Level ±16 dB (freq: from 700Hz to 6 KHz)
HIGH
center frequency 10 KHz; level ±16 dB
OUTPUTS
LINE OUT:
balanced XLR - Maximum voltage 12 Vpp
EFFECT SEND:
unbalanced, max voltage 20 Vpp (pre EQ) (send/return wired in parallel)
TUNER OUT:
unbalanced, max voltage 2 Vpp
SPEAKER OUT:
one speakon combo + 1/4" jack
(LITTLE MARK VINTAGE D2 1000 features only a speakon speaker out)
speaker outputs are in parallel and minimum impedance load for the
amp is 4 ohm
OTHER:
WEIGHT:
5.51 lbs/ 2.5 kg (LITTLE MARK VINTAGE D2)
6.83 lbs/ 3.1 kg (LITTLE MARK VINTAGE D2 1000)
WIDTH:
10.87"/ 27.6 cm
DEPTH:
9.84"/ 25 cm
HEIGHT:
3.27" / 8.3 cm
OUTPUT POWER:
500W RMS @ 4 ohm / 300W RMS @ 8 ohm (LM VINTAGE D2)
1000W RMS @ 4 ohm / 600W RMS @ 8 ohm (LM VINTAGE D2 1000)
POWER REQUIREMENT:
100V; 120V; 230V; 240V - 50/60Hz
(Voltage is factory preset according to region of sale).
04
WARNING: The LITTLE MARK VINTAGE D2 heads are manufactured to be used in the country where they
have been sold, and they are factory preset to that country's voltage. So make sure you're sending the
correct voltage to your amp before you connect it to the AC power.
Due to homologation issues, the voltage may not be changed.
Minimum ohm load for all Markbass heads is 4 ohms.
Rack ears do not come included with this head.
NOTE: Product specifications are subject to change without notice.
FUSES:
LITTLE MARK VINTAGE D2
T 10A 250V for 100V setting;
T 8A 250V for 120V setting;
T 4A 250V for 230V/240V setting
LITTLE MARK VINTAGE D2 1000
T 12A 250V for 100V setting;
T 10A 250V for 120V setting;
T 8A 250V for 230V/240V setting
Publicité
