Milwaukee 48-22-8536 Manuel De L'utilisateur page 4

ASSEMBLY
Be sure to follow the assembly in-
CAUTION
structions for the appropriate
chest/cabinet. Do not use power tools to as-
semble chest/cabinet. Tighten bolts with hand
wrenches.
Tools Required (Not Included)
Phillips Safety
screwdriver goggles
Hardware Included
NOTE: Items not shown in actual size. Hardware
lengths are approximate.
Hardware Item
AA
BB
CC
DD
EE
FF
Item
5" Swivel caster
10 mm
Wrench
Description
Bolt M6 x 16L
Steel washer
Bolt M8 x 18L
Screw M4 x 12L
Screw M4 x 16L
Screw M6 x 16L
Description
Side handle
with brake
5" Rigid caster
Bracket
Front bumper
Rear bumper
13 mm
NOTE: Begin product assembly close to the final
Wrench
intended location of your chest/cabinet. This product
is heavy and may be difficult to move after assembly.
Attach the side handle to the rolling cabinet using
Quantity four bolts (AA). The side handle can be attached to
either side of the rolling cabinet, but must match the
end where the swivel casters are installed.
4
NOTE: The holes in the cabinet are tapped and do
not require nuts.
16
16
20
20
2
Quantity
1
CAUTION
2
Do not overtighten the screws.
1. Ensure all cabinet drawers are securely locked into
2
place using the key lock on the rolling cabinet.
2. Lay the rolling cabinet on its back. Use the packag-
ing material to protect the finish.
3. Mount the two swivel casters with brake to the
2
rolling cabinet using four bolts (CC) and washers
(BB) per caster. The swivel casters with brake
must be installed on the end of the cabinet with
8
the side handle.
4. Mount the two rigid casters to the opposite end
2
of the rolling cabinet using four bolts (CC) and
washers (BB) per caster.
5. Tighten all bolts securely with a wrench.
6. Return the rolling cabinet to its upright position.
4
Chest corner extrusion
Cabinet corner extrusion
Cord storage bracket
Bottle opener
Attaching the Side Handle
Installing the Casters
Two people may be required to
complete installation.
2
2
4
1
AA