Publicité
Les langues disponibles
Les langues disponibles
Flange Nut
Figure 11
CAUTION:
FAILURE TO SECURE THE REFLECTOR BOLT
MAY RESULT IN A RATTLING OR HUMMING NOISE.
4.
After the reflector bolt is secure, raise the grill/reflector up into position
and plug the reflector into the appropriate receptacle. Secure the
assembly to the reflector bolt using the acorn nut and lock washer.
Install the included LED lamp into the lamp holder by lining up the pins
on the lamp base to the socket of the lamp holder and turning the lamp
body clockwise until the lamp snaps into place and is firmly seated in
the lamp holder (Figure 12).
Figure 12
5.
Reinstall the lens into the grill.
6.
Restore power and test your installation.
Trouble
1. Fan does not operate when the switch is on.
2. Fan is operating, but air moves slower than normal.
3. Fan is operating louder than normal
6727919 Rev. G 11-18
Motor Clip
Mounting Bolt
Nut
Reflector
Grill
Lens
Tabs
Troubleshooting Guide
Probable Cause
1a.
A fuse may be blown or a circuit tripped.
1b.
Connector plug from motor is not plugged in. 1b.
1c.
Wiring is not connected properly.
1d
Motor has stopped operating.
2.
Obstruction in the exhaust ducting.
3a.
Motor is loose.
3b.
Fan blade is hitting housing of unit.
SECTION 7
Use and Care
CAUTION:
OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT.
CAUTION:
Changing the Lamp
Remove the light lens by squeezing at the tabs and pulling down (Figure
13). Remove lamp by gently twisting the lamp base counterclockwise while
applying outward pressure. Installation is the reverse of removal. Replace
with Air King model AK6LED40 or a compatible GU24 6 watt LED lamp
(models BFQLA50, BFQLA120 - compatible GU24 11.5 watt LED lamp).
Tabs
Figure 13
Cleaning the Grill
Remove grill and use a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING
POWDERS. Completely dry grill before reinstalling. Refer to instructions in
Section 6 Finishing the Installation, to reinstall grill.
Cleaning the Fan Assembly
Unplug the motor cord from receptacle. Wipe all parts with a dry cloth or
gently vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
Plug the motor cord back in and restore power.
Suggested Remedy
1a.
Replace fuse or reset circuit breaker.
Turn off power to unit. Remove Grill and plug motor into receptacle
in housing. Restore power to unit.
1c.
Turn off power to unit. Check that all wires are connected.
1d.
Replace motor.
2.
Check for any obstructions in the ducting. The most common are bird
nests in the roof cap or wall cap where the fan exhausts to the outside.
3a.
Turn off power to unit. Remove grill and check that all screws are fully
tightened. Restore power to unit.
3b.
Call your dealer for service.
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED
ALLOW BULB TO COOL BEFORE REPLACING.
4 of 12
Publicité
