Publicité
Les langues disponibles
Les langues disponibles
Instructions for use, maintenance, and safety
BLASTER-DRYER
VIVOG D2500 (2400 WATTS)
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE
USING THE MACHINE
Important: please follow the guidelines for use
The VIVOG D2500 dryer-blaster has been designed exclusively for use
with dogs and cats. It is fitted with a 2-position 30° or 70° heater
controlled with a 3-way switch (30° - AR – 70°). The airflow is also
controlled with a 3-way switch (1-AR-2) and a regulator. The heater only
works when the motor is turning. The VIVOG dryer-blaster is very
powerful (max 2,400 W). Since the use of pulsed air is very different to
that of ventilated air, it is not advisable to use the device continuously for
more than 15 minutes. The heater is controlled by a switch so that you
adjust the temperature of the air outlet as a function of air flow and room
temperature. Hold the end of the ait outlet tube at a sufficient distance
from the animal without staying in the same place on the animal for more
than ten seconds. To obtain the best results when styling, it is advisable
to brush the fur with a soft brush without touching the skin.
SAFETY PRECAUTIONS
Before turning on your blaster-dryer please read and follow these
instructions carefully. Check that the voltage indicated on the blaster-
dryer corresponds to your electrical supply. Your electrical supply should
meet current safety standards and be fitted with a 30 mA circuit breaker.
- Never submerge the blaster-dryer in water and never use in wet places.
- Never use the blaster-dryer near a bathtub, shower, or recipients that
contain liquids; if the blaster-dryer fall into water and they are connected
to the power supply, unplug the power supply before picking up the
blaster-dryer.
- Never use the blaster-dryer if they are dropped into water: take the
blaster-dryer to the VIVOG technical assistance centre for inspection and
repair if necessary:
VIVOG SAS
2 rue de la Briaudière – CS40001
37515 BALLAN-MIRÉ CEDEX - FRANCE.
Tel. +33 (0)2 47 73 38 38 - fax. +33 (0)2 47 73 38 48
email : infos@vivog.fr
- If the blaster-dryer stop working or do not work correctly, turn them off
and do not open them. Repairs should only be performed at the VIVOG
technical assistance centre.
- If the power cable is damaged, it should be discarded and replaced with
an identical model.
- Never use the blaster-dryer with wet hands and/or feet.
- Never use the blaster-dryer barefoot.
- Never use the extension lead in rooms that are destined for bathing or
showering without taking specific precautions.
- Never pull the power cable or the blaster-dryer to unplug it from the
power socket.
- Never allow children or unskilled persons to use the blaster-dryer
without supervision.
- Never use the blaster-dryer for anything other than the purpose for
which it is designed.
NEVER OPEN THE MACHINE
CLEANING AND MAINTENANCE
Follow the instructions for use, safety, and maintenance:
- The device should not be opened under any circumstances, do not
insert any thin or pointed objects such as a screwdriver into the device.
- Before cleaning, the device should be unplugged from the power source.
- Particular care should be paid to the air inlet (this should be vacuumed
before each use using a dust vacuum). Once a week, wash the filter with
water (water + soap) to rid it of any dust that could impede correct
operation. To do this, unscrew the filter holder, wash the filter, dry it, and
then replace it.
At least once a year, it is advisable to send your Dryer-blaster to the after
sales service (ASS) of VIVOG for servicing and complete cleaning of the
motor and heating elements.
If you follow these guidelines, you will increase the lifespan of your device
and avoid faults.
PROBLEMS AND CAUSES OF POSSIBLE FAILURES
The dryer does not work:
1) Check the 220/240 V power supply at the plug.
2) The cable, switch, motor, or other is defective: send the dryer back to
the ASS of VIVOG for repair.
- The dryer only heats intermittently:
1) The safety device of the heater is on: check that the filter is clean.
2) The heater does not work properly: get it changed by the ASS of
VIVOG.
TECHNICAL SPECIFICATIONS
Blaster-dryer: .................................. 220 – 240 V - 50Hz –2400W
(Motor 1400 W – heater 1000 W)
FREE-STANDING INSTALLATION
- Unscrew the safety plates on the
base then position the dryer.
- Block the feet of the dryer using
the safety plates and wing nuts
provided.
- Unscrew the butterfly wheel from
the foot pole.
- Place the pole on the 4-foot stand with wheels. Re-screw the wheel and
tighten.
- Place the dryer-blaster on its stand.
GUARANTEE
The blaster-dryer is guaranteed for a period of 12 months from the date of
purchase, the guarantee terminates at this time even if the blaster-dryer
have not been used. It is therefore advisable to keep the proof of
purchase (receipt and original packaging).
The guarantee is applicable for normal conditions of use and not
intensive, with regular maintenance of all parts.
The guarantee covers all mechanical and electrical manufacturing defects.
The replacement or repairs of parts that are subject to normal wear, such
as the power cable, are therefore excluded.
Any repairs made during the guarantee period do not result in a
prolongation of the latter.
The guarantee is not valid if the machine has been opened or damaged
as a result of negligence, inexperience, or during transport.
The replacements or repairs covered by the guarantee are free of charge
by sending the machine directly, in its original packaging, with proof of
purchase to:
VIVOG SAS
2 rue de la Briaudière - CS 40001
37515 BALLAN-MIRÉ CEDEX - FRANCE.
Tel.: +33 (0)2 47 73 38 38 – Fax. +33 (0)2 47 73 38 48
email : infos@vivog.fr
Shipping costs are at the expense of the purchaser.
Publicité
