Publicité
Tube
User manual
Thank you for purchasing the Lightpro Tube.
This document contains the required information for
correct, efficient and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Tube can be used in combination with
the Lightpro Juno Tube. It can be placed in the ground
using the supplied ground spike, but can also be used
for wall mounting. This product may only be used as
outdoor lighting in combination with the Lightpro
12-volt system. Any alterations made to the product
may have consequences for the safety, guarantee and
correct functioning of the product and/or other parts of
the system.
SPECIFICATIONS
Product
Article number
Dimensions (h x Ø)
PACKAGING CONTENT
[Figure A]
1. Tube
2. Screws
3. Dowel
4. Allen keys
5. Spacer
6. Mounting blocks
7. Cover caps
8. Insert
9. Plug
10. Plug attachment
11. Cover caps of the tube
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Tube
215A
1200 x 20 mm
INSTALLATION
[Figure B]
1. Secure the tubes to each other with the insert and
tighten the screws with the Allen key.
2. Place the cover cap on the tube.
OPTION 1: INSTALLATION ON THE GROUND.
[Figure B]
1. Place the plug attachment on the pipe and tighten
the screws with the Allen key.
2. Mount the connector on the connector attachment.
OPTION 2: WALL-MOUNTED INSTALLATION.
[Figure C]
Place the two mounting blocks in the desired location.
1. Screw the screw into the wall at the desired location.
2. Place the spacer over the screw.
3. Screw the mounting block onto the screw.
[Figure D]
1. Slide the pipe through one of the mounting blocks.
Then slide the mounting blocks for the spotlight(s)
onto the pipe.
2. Slide the tube through to the 2nd mounting block
on the wall. Make sure that the cable guide is at the
back and then screw it onto the front of the mounting
block.
3. Place the cover cap at the back.
MOUNTING SPOT
[Figure D]
1. Place the friction ring [1] on the mounting block [6].
2. Turn the spotlight with the cables as a package on
the mounting block until you begin to feel resistance
and slide the lamp to the desired position.
3. Slide the mounting blocks for the spotlight(s) to the
desired position.
4. Secure them at the back with the set screw and place
the cover cap [7].
[Figure E]
Route the cable by pushing it into the recess at the
back of the tube.
Carefully slide the mounting blocks over the tube
when the cable is in the tube to avoid damaging the
cable.
Repeat this step in case more spots are mounted.
Publicité
