kayami 2000 ST Manuel D'instructions page 24

OPERATION
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been
used for a long period of time the heaters may emit some smell and fumes. This will disappear when the heater has
been on a short while.
Heat Controls
The heater has 3 heat settings:
Select the one required by switching on a single or combination of rocker switches. If the heater includes a timer, then you
will need to ensure that the oveeride switch is set to the "I" postion. For low heat switch on only the 750W rocker switch,
for medium heat the 1250W switch only, and for maximum outpout both the 750W and 1250W switches should be switch
one, to provide 2000W. (PIC-1)
Thermostat Control
The convector heater can be adjusted to maintain a constant room temerature by using the thermostat. Rorate the control
clockwise to turn on and increase the room temperature. Use along with one or more of the heater switches turned on.
When the room has reached the required temperature the light(s) in the rocker switch(es) will turn off. Please not that if the
indicator light(s) are not lit when the heater is switched on:
Turn the thermostat control clockwise to a higher setting.
Eunsure that the override switch on th timer is set to the "I" position.
(PIC-1)
Using the Timer Control (Only for DL06 TIMER)
Turn the clock dial clockwise until the correct time alighs with the pointer (24-hour clock). Raise the time segments for the
required heater on/off times and set the override switch to �� Timer postion. Adjust the heater rocker switcheds and
thermostat as required. (PIC-2)
Note: - When using in timer mode, due consideration should be given to the fact that the heater may come on whilst
unattended.
PIC-1
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.
Heat Switches
Thermostat Knob
Override Switch
Pointer
PIC-2
Time Segments
24