Classic Accessories Stellex 20-144-070501-00 Mode D'emploi

Instructions:
CAUTION
If your boat is new, use of this product
is not recommended within the first
four weeks of ownership of the boat.
Some compounds used in new boats
can release gases that will cause the
dyes in boat covers to transfer to the
boat, potentially staining the boat or its
components. Boat covers can be used
safely after this introductory period.
Installation
1. Cover sharp points (such as
windshield corners) with cloth or a
sponge to avoid stressing or tearing
your boat cover.
2. Drape your cover over your boat with
the tapered end marked "FRONT" at
the bow.
3. Pull your cover below the rub rail
around the entire boat.
4. Your cover includes quick-release
straps that secure your cover to your
boat. There are long straps with clips
on two ends and three short straps that
have a clip on one end and a loop on
the other. Locate the shortest strap with
the looped end. Push the loop through
the bow eye on your boat, run the clip
end of the strap through the strap loop,
and clip the strap into the socket above
on your cover.
5. Locate the remaining two straps with
looped ends—these are for the stern.
Secure the looped end of each strap
to your trailer or boat and clip into the
corresponding cover socket above.
6. The remaining long straps secure the
sides of your cover. To attach a strap
clip one end into a socket sewn on your
cover. Toss the unconnected end of the
strap under your boat then connect the
end to the corresponding socket on the
opposite side of your cover.
7. After attaching ALL of the straps
(don't forget the bow and stern straps)
cinch all straps tight and adjust their
length as necessary to get a tight fit.
20-144-070501-00, 20-145-080501-00, 20-146-090501-00, 20-147-100501-00, 20-148-110501-00, 20-149-120501-00
20-127-080501-CT, 20-128-090501-CT, 20-129-110501-CT, 20-130-120501-CT
20-164-070501-MFF, 20-165-080501-MFF
Stellex Boat Cover
™
Trailering
To use your Stellex Boat Cover when
trailering you MUST use all the included
straps—failure to do so will invalidate
your warranty.
Be sure to check that all the straps
are tight and firmly attached. After
driving the first mile, stop and check
your cover to ensure that all straps are
secured correctly.
Cleaning and Care
Proper care will extend the life of your
boat cover.
Cover support poles will help
prevent water from pooling on your
cover (sold separately).
If your boat cover becomes dirty,
it can be cleaned with lukewarm water
and a soft brush. DO NOT USE SOAP
—it can damage the protective coatings
on your cover.
Storage
Be sure your cover is completely dry
before you store it for any
extended period.
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 © 2 0 1 3
c l a s s i c a c c e s s o r i e s . c o m
12cB51_15390