Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation – Drilling and Driving
Pocket-Hole Screws
1
Drill Pocket Holes
WARNING
When drilling, always ensure the workpiece is clamped securely.
a.
Place your prepared drill bit (B) with stop collar (D) into your drill.
b.
Insert your drill bit into the drill guide (1) and bring your drill up to speed
before contacting the workpiece to ensure correct rotation of the drill bit.
c.
Drill until the stop collar (D) stops going any deeper due to contact
between the stop collar (D) and drill guide (1). Remove the drill bit (B) from
the drill guide while the drill bit is still rotating.
d.
When done drilling pocket hole(s), pull the trigger (2) to release the
clamping pressure, and then remove your workpiece.
2
8
1
D
B
Publicité
Chapitres
Table des Matières
