Technical Data; Before Starting The Equipment - EINHELL Bavaria BEH 5041 Mode D'emploi D'origine

Anleitung_BEH 5041_SPK7a__ 06.05.13 10:59 Seite 10
GB

5. Technical data

Voltage 230V ~ 50Hz
Power consumption
Cutting length
Cutter rail length
Tooth spacing
max. cutting ø
Cuts/min
Sound pressure level L 75,96 dB(A)
pA
Sound power level L 95,96 dB(A)
WA
K uncertainty
Vibration on steady grip a
hv
Vibration in handle a
hv
K uncertainty
Weight
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
10
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
500 W 3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
410 mm
is not properly guided and maintained.
450 mm
Warning! The electric power tool generates an
16 mm electromagnetic field during operation. Under certain
circumstances this field may actively or passively
12 mm
impede medical implants. To reduce the risk of
3500
serious or fatal injuries, we recommend persons with
medical implants to consult their doctor and the
manufacturer of the medical implant prior to using the
equipment.
3 dB(A)
2,785 m/s 2

6. Before starting the equipment

3,298 m/s 2
1.5 m/s 2
Before you connect the equipment to the mains
3,1 kg supply make sure that the data on the rating plate
are identical to the mains data.
Fitting the hand guard (Fig. 3a-3b)
Attach the hand guard (Fig. 3a/Item 2) in the direction
of the arrow as shown in Figure 3a. Then secure with
the two screws (Fig. 3b/Item 8).
7. Operation
The hedge trimmer is equipped with a two-handed
safety switch. The machine works only when the
switch on the steady grip (Fig. 4/Item A) is pressed
with one hand and the switch on the handle (Fig.
4/Item B) is pressed with the other hand.
Releasing any of the switches will bring the hedge
trimmer to a stop.
In so doing, please check the running of the
blades.
b Please check that the blades function correctly.
The blades cut on both sides and run in opposite
directions to each other, for guaranteed high
cutting performance and quiet operation.
b Fasten the extension cable to the cable holder
before starting to use the machine (see Fig. 4).
b For use in the open air you must only use
extension cables certified for the purpose.
Tips on use
b The hedge trimmer can be used not only for
trimming hedges but for trimming shrubs and
bushes as well.