Learning Function - Aiwa MF 350 Mode D'emploi

All manuals and user guides at all-guides.com

Learning function

The MF-350 offers a special Learning feature that allows you to
copy almost any function from your original remote control onto
the keypad of the MF-350.
Before you start:
• Make sure your original remote is working correctly.
• Make sure neither your MF-350, nor your original remote control
is pointing at your device.
• The MF-350 can learn approximately 30 functions.
• Please make sure not to use the learning procedure when in
direct sunlight or under incandescent lights.
Example: To copy the "mono/stereo" function from your
original TV remote control onto the A-key of your
MF-350.
1. Place the MF-350 and your original remote control on a
flat surface. Make sure the ends which you normally
point at your device are facing each other. Keep the
remotes at a distance of 2 to 5 cm.
2. Press and hold the SETUP key until the red light blinks
twice. The red light will blink once then twice.
3. Press 9 7 5 (the red light blinks twice).
4. Press the device key (e.g. TV key) on the MF-350 remote to
select the mode to which you want to copy the learned
function.
5. Press the key (e.g. A key) on the MF-350 remote where you
want to place the learned function. The red light will flash
rapidly.
6. Press and hold the key (on your original remote control)
that you want to copy until the red light blinks twice (e.g.
mono/stereo key).
7. If you want to copy other functions within the same mode,
simply repeat steps 5 and 6 pressing the next key you want to
copy by learning.
8. To exit the learning mode, press and hold the SETUP key
until the red light blinks twice.
22