Beper BP-2116 Manuel D'instructions page 27

Wrist blood pressure monitor Use Instructions
Power Off
The " " button can be pressed to turn off the unit in any mode. The unit can turn off the
power itself about 3 minutes no operation in any mode.
Safety Precaution: If pressure in cuff becomes too extreme while testing, press the " "
button to turn power off.
The cuff pressure will rapidly dissipate once the unit is off.
Memory Check
With power off, you may check past test results by using the " M" buttons.
Upon activating test results, you can press the "M "buttons to scroll through all test results
stored in memory. The LCD will display the last measurement memory as NO:1 reading.
Memory Deletion
Memory may be deleted while in Memory Check mode. Press and hold the " " button
for approximately 3 seconds to delete all memory records . The monitor will beep indicating
successful deletion and then transfer into testing mode. Then press the " "
button to turn the unit off.
Note: Memory cannot be recovered once it has been deleted
Low Battery Indicator
4 short warning beeps sound when battery life is depleting and unable to inflate cuff for
testing. The " " appears simultaneously for approximately 5 seconds prior to shutting
down. Replace batteries at this time. No memory loss will occur throughout this process.
27