Publicité
Les langues disponibles
Les langues disponibles
42
Tighten the 2 set screws on the
yoke once the downrod is in place.
45
Thread the lead wires through the
motor housing cover
48
Thread the leadwires through the
canopy and Place the canopy over
the downrod.
51
Pull the hanger ball up tight against
the pin and securely tighten the
setscrew in the hanger ball. a loose
setscrew could create fan
wobble.
43
Clip
Place the motor housing on the polyfoam
as shown, then locate the mounting plate
to the housing by aligning the clips on
the housing with holes in the mounting
plate
46
Place motor housing cover over the
mounting plate.
49
Thread the leadwires through the
hanger ball and place onto the
downrod.
52
Hang assembled fan to the mounting
bracket installed to ceiling in previous
step.
44
Clip in
tion
Hold the motor housing and turn mount-
ing plate clockwise by screwdriver to hold
it with housing in position. Make sure
that the clips are engaged with the
mounting plate well.
47
Install motor housing cover to the
mounting plate with 3 screws.
50
Position the pin through the two
holes in the downrod and align the
hanger ball so the pin is captured in
the groove in the top of the hanger
ball. note: pin must be installed
with downrod and hanger ball.
53
Safety cable installation
Safety cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
Fan and light kit combinations over 35 lbs, in
both flush and downrod mode the safety cable
must be installed into the house structure
beams using the 3" lag screws,washers, and
lock washers. provided. Make sure that when
the safety cable is fully extended the leadwires
are longer than the cable and no stress is
placed on the leadwires.
posi-
Publicité
