MSW MINIAC GO GPS Manuel D'instructions

MINIAC GO GPS
Thank you for purchasing an MSW
that having essential accessories makes a good ride great.
WARNING: Cycling can be dangerous. Bicycle products should be
installed and serviced by a professional mechanic. Never modify your bicycle
or accessories. Read and follow all product instructions and warnings
including information on the manufacturer's website. Inspect your bicycle
before every ride. Always wear a helmet.
WARNING: Please read over the following information before using the
MSW Miniac Go GPS.
• Never use the cycling computer in combination with other medical/
implanted electronic equipment and devices (especially pacemakers, EKG
equipment, TENS equipment, or cardio-pulmonary machines). If you are
severely ill or pregnant, please consult your doctor before using cycling
computer. Keep this device away from children. It contains batteries,
which might be swallowed by children.
• As is the case with most wireless electronic devices, interference can
sometimes cause inaccurate display readouts. Avoid using your cycling
computer near common sources of interference like high-voltage power
lines, air conditioning motor units, fluorescent lights, wristwatches,
mobiles, and some other computers.
For additional product and safety information go to: www.mswbike.com/safety.
COMPATIBILITY
The MSW Miniac Go GPS-322 is intended for use on roads and paved trails
as well as ASTM Condition 2 use. This includes smooth paved roads,
unpaved and gravel roads, and trails with moderate grades where loss
of contact with ground may occur but drops are less than 6" (15cm).
The Miniac Go GPS-322 head unit mounting bracket is compatible with most
handlebar diameters.
INCLUDED PARTS
A
Please check that all the following items have been included with the cycle
computer before starting.
A Miniac Go GPS
B Rubber pad
C Bracket
D Micro USB cable
E 4 rubber ties
6400 WEST 105TH STREET // BLOOMINGTON, MN 55438 // 1-855-883-6563 // WWW.MSWBIKE.COM
225382 10/19 | 85-001161_INST_A
Miniac Go GPS! At MSW
®
B D
C E
we believe
®
INSTALLATION
MOUNTING THE BRACKET
Fit the rubber pad to the back of the bracket and use the rubber ties
to attach it to the bar or stem (Figs. 1, 2).
Place the cycle computer on the bracket and secure it by turning clockwise
(Fig 3).
MAIN DISPLAY AND BUTTON FUNCTIONS
GPS Indicator
Battery
Average Speed
Trip Time
SET Button / Backlight
TURN ON/OFF
Hold SET button for 3 seconds to turn off the device. Press SET/SELECT
button to turn on the device.
MODE CHANGE
Mode One: Average Speed/Trip Time/Trip Distance
Mode Two: Maximum Speed/Clock/ODO
SET MODE
Hold SET and SELECT buttons together for 3 seconds to go to set mode.
SET MPH/KPH
Set MPH/KPH
Cycle Computer Rubber Pad
Bracket
Rubber Pad
Figure 1
Speed
Clock
Distance
SELECT Button
Figure 4
Set ODO Set 12/24H
Bracket
Rubber Ties
Figure 2
Figure 3
Set Clock
Figure 5