Operating Instructions; Lubrication; Recommended Hookup - Campbell Hausfeld SB101000 Instructions D'utilisation

Operating Instructions

Important Safety Instructions
(Continued)
Do not make any
modifi cations to
the tool without fi rst obtaining written
approval from Campbell Hausfeld. Do
not use the tool if any shields or guards
are removed or altered. Do not use the
tool as a hammer. Personal injury or
tool damage may occur.
Disconnect air
supply and release
tension from the pusher before
attempting to clear jams because
fasteners can be ejected from the front
of the tool. Personal injury may occur.
AIR SOURCE
a. Never connect to an air source that
is capable of exceeding 200 psi.
Over pressurizing the tool is able
to result in bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only
clean, dry, regulated compressed air
at the rated pressure or within the
rated pressure range as marked on
the tool. Always verify prior to using
the tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.

Recommended Hookup

Outlet
Tank Pressure
Pressure Gauge
Gauge
Regulator
www.chpower.com
type of reactive gases,
including, but not limited
to, oxygen and combustible
gases, as a power source. Use fi ltered,
lubricated, regulated compressed air
only. Use of a reactive gas instead of
compressed air may cause the tool
to explode which will cause death or
serious personal injury.
regulated compressed air source to
limit the air pressure supplied to the
tool. The regulated pressure must not
exceed 100 psi. If the regulator fails, the
pressure delivered to the tool must not
exceed 200 psi. The tool could explode
which will cause death or serious
personal injury.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
Operating Instructions

LUBRICATION

This tool requires lubrication before
using the tool for the first time and
before each use. If an inline oiler is
used, manual lubrication through the
air inlet is not required on a daily basis.
damaged by excessive lubrication.
Proper lubrication is the owner's
responsibility. Failure to lubricate the
tool properly will dramatically shorten
the life of the tool and void your
warranty.
Regulator
Quick
Outlet
Coupler
Do not
use any
O
CO
2
Use only a pressure-
The work surface
can become
Quick
Plug
Air
Hose
4
1. Disconnect the air
supply from the tool
to add lubricant.
2. Turn the tool so the
air inlet is facing up.
Place 4-5 drops of 30
W non-detergent oil
into air inlet. Do not
use detergent oils, oil additives, or
air- tool oils. Air tool oils contain
solvents which will damage the
tool's internal components.
3. After adding oil, run
tool briefly. Wipe off
any excess oil from the
cap exhaust.
RECOMMENDED HOOKUP
The illustration below shows the
recommended hookup for the tool.
1. The air compressor
must be able to
maintain a minimum
of 60 psi when the
tool is being used. An inadequate air
supply can cause a loss of power and
inconsistent driving.
2. An oiler can be
used to provide oil
circulation through
the tool. A filter can
be used to remove liquid and solid
impurities which can rust or "gum
up" internal parts of the tool.
Quick
Coupler
Swivel
Plug
OIL
60 psi
Min.
100 psi
Max.